TPS Calculator
TPS means two completely different things depending on who is asking. In Quebec it is the Taxe sur les produits et services, the French name for Canada’s 5% federal Goods and Services Tax. In tech it is transactions per second, the average throughput of a payment gateway, a database or a blockchain. This calculator serves both meanings, one tab each, and this page is careful about where the two stories meet: the Quebec tab computes the federal tax only, and the combined Quebec bill is worked out in prose below.
Standard rate is 5%. Adjust it for historical calculations if needed. This tab computes the TPS (federal GST) line only; it does not add Quebec’s TVQ.
The result is the average throughput over the window you measured. A short burst can read far higher than the sustained rate.
Tax figures are rounded to the cent and throughput to two decimals. This tool is general information, not tax advice; check the current rates with Revenu Québec and the Canada Revenue Agency before filing anything.
Quick Answer
A $1,200 sale at the standard 5% TPS carries $60.00 of TPS, for a $1,260.00 total with TPS. A system that processes 300 transactions in 60 seconds runs at 5.00 transactions per second. Both examples are pre-filled in the calculator above, one per tab. The Quebec tab stops at the federal line: the full Quebec bill on that $1,200 sale is $1,379.70 once the 9.975% TVQ is added, as worked out in the Quebec section below.
Correction to the old page: TVQ is not calculated on the TPS-inclusive amount
The previous version of this page said Quebec's TVQ applies on top, on the TPS-inclusive amount. That was the pre-2013 method. Since January 1, 2013, Revenu Québec calculates the QST (TVQ) at 9.975% on the selling price excluding the GST, and the GST at 5% on the same selling price. The combined rate is therefore a plain sum, 14.975%, not the 15.47% the stacked method would give. On a $1,200 sale the stacked method would overstate the bill by $5.99 ($1,385.69 instead of $1,379.70). This rewrite corrects the mechanism everywhere it appears, while the tool itself is unchanged: it never computed TVQ, and it still does not.
Key takeaways
- TPS is the Quebec French name for the federal GST. Outside Quebec the same 5% tax is called GST, not TPS.
- The Quebec tab computes the TPS line only. Add TVQ separately at 9.975% of the selling price for the full Quebec bill.
- Both Quebec taxes share the same base, the selling price. That is why the combined rate is exactly 14.975%.
- Throughput is an average over the window you measured. A burst measured over 10 seconds and a day measured over 86,400 seconds are different numbers even for the same system.
- The tool has no reverse-tax mode and no per-user mode. The reverse formula is given in prose so you can still strip tax out of a total by hand.
How to use the TPS calculator
Pick the tab that matches your question, enter two numbers, and read the result. The results stay hidden until you calculate, and switching tabs clears the result so a tax answer can never be mistaken for a throughput answer.
- For Quebec tax: stay on the TPS tax tab, enter the sales amount before tax and the TPS rate (5% is pre-filled), then click Calculate. The result names the TPS amount and the total with TPS.
- For throughput: switch to the Transactions per second tab, enter the number of transactions and the total time in seconds (300 and 60 are pre-filled), then click Calculate. The result reads in transactions per second to two decimals.
- Copy or share the result with the buttons in the results box.
- Reset restores the worked-example values (sale $1,200 at 5%, or 300 transactions in 60 seconds) rather than blanking the form.
Invalid inputs are rejected with a named message per field: a blank sales amount, a negative sale, a blank rate, a negative rate, a blank transaction count, a negative count, a blank time, or a time of zero or less. One quirk is preserved from the live tool and worth knowing: when the first field on a tab is invalid, the second field's range check is skipped and only the first error shows. Fix the first field and calculate again to surface the second.
The formulas
Both tabs are one division or one multiplication, and both are stated here exactly as the tool runs them.
Throughput: TPS = number of transactions ÷ time in seconds
Quebec combined (prose only, not a tool mode): TVQ = sales × 9.975 ÷ 100; full total = sales + TPS + TVQ = sales × 1.14975
Reverse (prose only): price before tax = total with both Quebec taxes ÷ 1.14975
The two TPS formulas share an abbreviation and nothing else. The tax formula multiplies a price by a percentage; the throughput formula divides a count by a time. Confusing them is easy in search results and impossible in this tool, because the tabs keep their inputs and their outputs apart. The tax rate calculator covers rate maths more broadly, and the sales calculator covers sale totals when the question is revenue rather than tax.
Worked examples, checked against this exact tool
Every tool row in this table is a real run of the calculator above. Type the inputs in and you get the same figures back.
| Case | Inputs | Tool output |
|---|---|---|
| Quebec sale | $1,200 at 5% | TPS amount: $60.00. Total with TPS: $1260.00. |
| Smaller Quebec sale | $250 at 5% | TPS amount: $12.50. Total with TPS: $262.50. |
| Payment gateway | 300 transactions in 60 seconds | Throughput: 5.00 transactions/sec. |
| Database benchmark | 5,000 transactions in 100 seconds | Throughput: 50.00 transactions/sec. |
| Hour-long load test | 120,000 transactions in 3,600 seconds | Throughput: 33.33 transactions/sec. |
The hour-long row is the one to remember when comparing systems. A gateway that bursts to 200 transactions per second for ten seconds and then queues everything has not demonstrated 200 TPS; it has demonstrated a ten-second burst. Sustained throughput, measured over the window the system must actually survive, is the number that plans capacity.
Quebec tax in full: TPS plus TVQ, and the geography trap
TPS is the Quebec name for the federal 5% GST. It is not a Quebec-only tax: the same federal tax applies at 5% in every province and territory, and outside Quebec it is simply called GST. What changes by province is the provincial piece. Quebec adds its own TVQ (QST) at 9.975%, administered by Revenu Québec, while Ontario folds its provincial piece into a 13% HST and the Atlantic provinces run 14% to 15% HST. Alberta and the territories charge the 5% GST alone.
| Sale before tax | TPS (5%) | TVQ (9.975%) | Full Quebec total |
|---|---|---|---|
| $100.00 | $5.00 | $9.98 | $114.98 |
| $250.00 | $12.50 | $24.94 | $287.44 |
| $1,200.00 | $60.00 | $119.70 | $1,379.70 |
Read the table by rows, not by adding the rounded TVQ figures in your head: $250 at 9.975% is $24.9375, which rounds to $24.94, and $250 plus $12.50 plus $24.9375 is $287.4375, which rounds to $287.44. The $100 row rounds the same way: 9.975% of $100 is $9.975, shown as $9.98, and the total is $114.98. Receipts round per line, so a till total can differ from this table by a cent or two depending on the store's rounding. The reverse direction is one division: a $1,149.75 Quebec total divides by 1.14975 to give a $1,000 price before tax. The percentage off calculator handles a similar strip-a-percentage-out problem when the question is a discount rather than tax.
Two limits apply to every number in this section. First, the standard rates assume a taxable supply at the standard rate; basic groceries, prescription drugs, most health and education services and other exempt or zero-rated supplies do not carry the full rate, and some goods carry special rates. Second, rates change: the 5% and 9.975% figures have held since 2013, but a filing decision should always be checked against the current Revenu Québec and Canada Revenue Agency pages, which are linked in the references.
Reading a throughput number honestly
Throughput answers "how many per second on average" and nothing else. A complete benchmark also reports latency (how long each transaction took), the error rate (how many failed), and whether the rate held up over the whole window. A system at 50 transactions per second with 5% errors is not faster than a system at 40 with none; it is a system dropping one transaction in twenty. A system that holds 50 per second for an hour is not the same as one that holds it for a minute before its queue fills. Peak throughput, the best short window, flatters every system, which is why capacity plans use the sustained rate at an acceptable error rate and latency, not the headline burst.
That is also why this tool deliberately stays simple. It divides the count you measured by the time you measured, and it does not pretend to know your latency, your errors, your concurrency or your transaction mix. A "transaction" in one benchmark can be a single payment authorisation and in another a batch of ten database statements, so two TPS figures from different test harnesses are not comparable unless the transaction definition, the window and the pass criteria match. Compare a system against itself across releases, on the same harness, and the division becomes a genuinely useful trend line.
What competing calculators miss
Search results for this keyword split into two camps that never acknowledge each other, and each camp has its own blind spot:
- Quebec-only tax tools compute GST plus QST and the total, and several offer the reverse direction (total back to price before tax) that this page's tool lacks. Their weakness is tunnel vision: a searcher who meant throughput gets nothing, and some older pages still describe the pre-2013 stacked QST method, which overstates a Quebec bill.
- Throughput-only tools divide transactions by seconds and stop, sometimes adding a per-user split (transactions divided by seconds times concurrent users). Their weakness is the opposite tunnel vision, plus a habit of presenting the average as if it were a capacity guarantee, with no word on latency, errors or sustained versus peak rates.
- Single-meaning pages that rank for both terms answer one meaning in the tool and the other only in prose, or bury the worked examples so deep that a searcher cannot verify the maths without reading the whole article.
- The gap this page fills: both meanings in one tool with verified examples for each, the corrected current Quebec mechanism stated plainly (same-base taxes, 14.975% combined), and the throughput caveats (average, not peak; latency and errors matter) that the division alone cannot show. The honest boundary is the missing reverse-tax mode: it is given as a prose formula, not silently added as a tool change.
Frequently asked questions
TPS stands for Taxe sur les produits et services, the French name for Canada's federal Goods and Services Tax. It is 5% on most goods and services, and in Quebec it is charged alongside the provincial TVQ.
Yes. TPS and GST are the same federal tax; TPS is simply the French term used in Quebec. Outside Quebec the same 5% tax is called GST, and in HST provinces it is blended with the provincial piece into one combined rate.
14.975%: 5% TPS plus 9.975% TVQ, both calculated on the selling price. On a $1,200 sale that is $60.00 of TPS plus $119.70 of TVQ, for a $1,379.70 total. This tool computes the TPS line only; add the TVQ line by hand from the table above.
The order does not change the total under the current method, because both taxes are calculated on the selling price. Since January 1, 2013, the TVQ is not calculated on the TPS-inclusive amount; that stacked method ended in 2012 and would overstate a $1,200 bill by $5.99.
Multiply the pre-tax amount by the rate and divide by 100: $1,200 times 5 divided by 100 is $60.00. Add it to the sale for the total with TPS, which is $1,260.00 before any TVQ.
Divide the total by 1.14975. A $1,149.75 Quebec total divides by 1.14975 to give a $1,000 price before tax. This tool does not have a reverse mode, so the division is done by hand; the formula section above shows the working.
Throughput: how many transactions a system completes each second on average over the window you measured. It is the headline number for payment gateways, database benchmarks, web services and blockchain networks, but it says nothing on its own about latency or errors.
Because the average divides the whole window, including quiet spells and queueing, while the peak is the best short burst. Capacity plans should use the sustained average at an acceptable error rate, not the burst, since the burst is the number a system hits briefly before it starts falling behind.
No. This page covers the Quebec sales tax and the throughput metric; the UK Teachers' Pension Scheme is unrelated to either, and its pension calculations belong on a pensions page, not here.
Add This Calculator to Your Website
Embed this calculator on your own site with the code below. Pick a size to preview it live, then copy the code.
Powered by Calculator Zilo
References
- Revenu Québec. Basic Rules for Applying the GST/HST and QST (GST calculated at 5% on the selling price; QST calculated at 9.975% on the selling price excluding the GST; Revenu Québec administers the GST/HST in Quebec). Accessed October 24, 2026.
- Canada Revenue Agency, via Canada.ca. GST/HST for digital-economy businesses: What rate to charge (5% GST in Quebec, Alberta, British Columbia, Manitoba, Saskatchewan and the territories; 13% HST in Ontario; 14% in Nova Scotia; 15% in New Brunswick, Newfoundland and Labrador and Prince Edward Island). Accessed October 24, 2026.
- BrowserStack. Throughput vs Latency (throughput measures system capacity in transactions or data per second; latency measures responsiveness; throughput rises then falls as load passes saturation). Accessed October 24, 2026.
- RadView. Benchmark Testing: Definition, Process and Best Tools (throughput defined as total successful requests divided by the time period, typically requests or transactions per second; error rate as failed requests divided by total requests). Accessed October 24, 2026.
- Al-Ali and co-authors, Computers (MDPI). Toward Intelligent Blockchain Consensus: A Machine Learning-Enhanced Redbelly Framework (throughput reported as peak sustained throughput at a reference operating point, distinguished from capacity under bounded offered load; latency reported alongside throughput). Accessed October 24, 2026.
